Event Materials Specifications
Use the following table to obtain size and positioning specifications for applying the Department's corporate symbols to the most commonly produced event materials — portable exhibit displays and roll-up banners. You can also view examples and download layout templates from this table.
Applications of Industry Canada's Corporate Look have been developed in accordance with these specifications for size and placement of FIP signatures and the "Canada" wordmark on departmental communications.
When producing banners, temporary signs, or other types of event materials, use the information presented here as a basis from which to work, and contact the Multimedia Services Section for advice.
1. Artwork for large formats is generally produced at one-quarter size; the measurements listed below for the FIP signature and the "Canada" wordmark are also at one-quarter actual size.
2. Measurements for the FIP signature in the table below are for the Industry Canada FIP signature. When using other FIP signatures (e.g., the Government of Canada FIP signature, Competition Bureau FIP signature or special operating agency FIP signatures) in place of the Industry Canada FIP signature, use the point sizes listed below as a guide and contact Multimedia Production for advice. When creating a FIP signature, see the design guidelines in the Federal Identity Program Manual.
3. When applying a departmental unique identifier in addition to the Industry Canada FIP signature and the "Canada" wordmark, ensure that the unique identifier is less prominent than the signature and wordmark.
(point size, width)
30 pt., 151 mm
Rate this page
The content of this page was useful to me.
- Date modified: