Industry Canada
Symbol of the Government of Canada

Spectrum Management and Telecommunications

    Next


CS-03 - Compliance Specification, Issue 9

1. Scope

This Specification, which is divided into eight parts, sets forth the minimum technical requirements for the registration of terminal equipment, terminal systems, network protection devices and associated connection arrangements. These technical requirements are intended to protect the public switched network from harm. Conformance to these technical requirements will not assure compatibility with wireline carrier services.

Throughout this document wherever the words terminal equipment (TE) appear they shall be read as "terminal equipment, terminal systems and network protection devices".

Amendments

The document contains the following parts:

  • Cover pages (PDF, 57 KB, 5 pages)
  • Part I specifies the requirements for analogue terminal equipment intended for connection to the public switched network (e.g. equipment connected to loop start lines, tie trunks, etc.)
  • Part II specifies the requirements for digital terminal equipment intended for connection to 1.544 Mbps (DS-1) digital facilities.
  • Part III specifies acceptable methods of connection for terminal equipment.
  • Part IV is a glossary of terms used throughout the document.
  • Part V specifies the requirements for the magnetic output from handset telephones for the purpose of coupling with hearing aids. These technical requirements are intended to ensure compatibility between hearing aids and handsets, thus providing persons with hearing aids reasonable access to the telephone network.
  • Part VI specifies requirements for Integrated Services Digital Network (ISDN) terminal equipment.
  • Part VII specifies technical requirements for limited distance modem terminal equipment and digital subrate terminal equipment.
  • Part VIII specifies technical requirements for a range of Digital Subscriber Line (xDSL) terminal equipment.

2. Associated Requirements

The following documents specify the requirements that shall be met with regards to declaration of conformity, registration, and marking of terminal equipment covered in Parts I, II, V, VI, VII and VIII of this document.

The CS-03 will be reviewed from time to time on the basis of experience gained as new technologies emerge. Industry Canada encourages comments and suggestions that will enhance the effectiveness of the specification. These may be forwarded to:

TAPAC Chairperson
Directorate of Telecommunication Engineering and Certification
Industry Canada
Suite 1302-A
300 Slater Street,13th Floor
Ottawa, Ontario
K1A 0C8
Canada

Telephone No.: (613) 990-4712
Facsimile No.: (613) 957-8845
E-mail: kwan.andy@ic.gc.ca

Issued under the authority
of the Minister of Industry

R.W. McCaughern
Director General
Spectrum Engineering Branch


Information on Downloading a PDF Reader
To access the Portable Document Format (PDF) version you must have a PDF reader installed. If you do not already have such a reader, there are numerous PDF readers available for free download or for purchase on the Internet:

    Next